ROLLING TOP GREENHOUSE BENCH
TOOLS REQUIRED FOR ASSEMBLY
Socket set, Open end wrench set, Phillips bit, Cordless
drill with 3/8" socket bit (Magnetic recommended).
BEFORE ASSEMBLY
Read through the assembly instructions to
familiarize yourself with the order in which
the parts are assembled. We suggest that
you clear & vacuum the area where the bench
is to be assembled. It is important that the
bench is assembled in the same sequence
as instructed.
HARDWARE
All assembly hardware is provided.
Bolt the top leg rail to the vertical leg supports using
(4) 5/16”-18 x 4-1/2” hex bolts with Nylock Nuts.
Locations are indicated by the red arrows in the
illustration.
STEP 2 STEP 1
Nylock Nut
5/16-18 x 1/2”
Hex Head Bolt
Nylock Nut
5/16-18 x 4-1/2”
Hex Head Bolt
Bolt the floor anchor brackets using
(4) 5/16”-18 x 1/2” hex bolts with Nylock Nuts
per bracket
Bolt the X leg braces in place with (4) 5/16”-18 x 1/2”
hex bolts with Nylock Nuts.
Locations are indicated by the red arrows in the
illustration.
This will complete the leg section assembly.
One of the top section assemblies has been shipped
assembled. Use this as reference for part orientation
and assembly of the remaining to sections.
Attach cross support pieces to the front and back side
table rail channels using (20) 1/4”-20 x 1/2” Flat
head screws and nylock nuts per top assembly. See
red arrows for mounting locations for each side.
STEP 3
Nylock Nut
STEP 4
1/4”-20 x 1/2” FLAT
HEAD Screws
Attach one end cap on each top assembly using
(5) 1/2” Hex head self tapping screws. Pilot holes
are drilled into the already mounted C channels for
positioning. See photo.
STEP 5
Attach the 4 U channel guides on the bottom side of
the table. Use (4) 1/2” Hex head self tapping screws
per bracket. Pilot holes are drilled for positioning.
View the bracket locations on the exploded view of
the first page or reference the assembled top.
1/2” SELF TAPPING
HEX HEAD SCREWS
1/2” SELF TAPPING
HEX HEAD SCREWS
STEP 6
STEP 7
Position leg assembles upright and space them apart
so tables guide brackets will set over the top leg rails.
Once positioned lay two of the pipe sections on the
top leg rail. With assistance, set the table in position
on the legs. Make sure the pipe sections are oriented
as shown in the photo with the table guide brackets.
Once positioned use (8) 5/16-18 x 5-1/2” bolts
with Nylock nuts and insert them through the
table guide brackets as indicated by the red
arrows.
Nylock Nut
5/16-18 x 5-1/2”
Hex Head Bolt
Insert the grate into the frame of the table. The
expanded metal sometimes has a tendency to
not lay flat. You can use the supplied 1/2” Hex head
self tapping screws to help aid in holding the metal
sheet flat. We recommend screwing the sheet around
the perimeter of the sheet.
Position the table into its final position.
The legs will need to be anchored directly to the
floor so the table will be rigid and operate properly,
take care that the legs are squared up and there is
equal clearance for the table brackets.
STEP 8
Repeat these steps for other tables. If
tables are being tied together attach the two sections
of tables together with the supplied brackets. Use
(4) 5/16-18 x 1/2” bolts with nylock nuts.
5/16-18 x 1/2”
Hex Head Bolt
Nylock Nut
